Shaped, Flat, Square, Round, Fine Wire, Plated and Un-plated
ASTM B265, AMS 4911, AMS 4928
Titanium 6Al-4V (Grade 5) Alloy Description
Stronger than commercially pure titanium alloys, titanium 6Al-4V (Grade 5). Among its many advantages the alloyis heat treatable, has an excellent combination of strength, corrosion resistance, weldability and formability.
Applications
Tension set rings
Bolts, bicycle parts
Biomedical implants
High-temperature structural applications in the aircraft industry
Chemistry Typical
Titanium: Balance
Vanadium: 4.0
Aluminum: 6.0
Hydrogen: 0.015 max
Nitrogen: 0.02 max
Carbon: 0.10 max
Iron: 0.25 max
Residual each: 0.10 max., total 0.40 max
Physical Properties
Density, 0.16 lbs/in³, 4.43 g/cm³
Mean Coefficient of Thermal Expansion: in/in/°F (mm/m/°C):
70- 212°F (20- 100°C): 4.78 x 10-6 (8.6)
Thermal Conductivity: BTU-in/h-ft-°F (W/m-°K):
At 70°F (21°C): 46.5 (6.7)
Modulus of Elasticity: KSI (MPa)
16.5 x 10³ (113.8 x 10³) in tension
Melting Point: 3020°F (1660°C)
Mechanical Properties at Room Temperature
Properties: Annealed (Typical)
Ultimate Tensile Strength: 135 KSI (950 MPa)
Yield Strength (0.2% offset): 125 KSI (880 MPa)
Elongation: 15%
Hardness: Rc 34
Properties: Tempered
Contact Ulbrich Wire with requirements.
Additional Properties
Corrosion Resistance
Refer to NACE (National Association of Corrosion Engineers) for recommendations.
Finishes
Inquire with Ulbrich Wire
Forms
Continuous Coils
Cut to lengths
Precision cutting
Heat Treatment
Titanium 6-4 (Grade 5) be hardened by cold working and heat treating.
Welding
For best results refer to: SSINA’s “Welding of Stainless Steels and Other Joining Methods”
Limitation of Liability and Disclaimer of Warranty: In no event will Ulbrich Stainless Steels and Special Metals, Inc., be liable for any damages arising from the use of the information included in this document or that it is suitable for the ‘applications’ noted. We believe the information and data provided to be accurate to the best of our knowledge but, all data is considered typical values only. It is intended for reference and general information and not recommended for specification, design or engineering purposes. Ulbrich assumes no implied or express warranty in regard to the creation or accuracy of the data provided in this document.
Copyright January 2014 Ulbrich Stainless Steels & Special Metals, Inc. – Revision 6.1.2015
