Shaped, Flat, Square, Round, Fine Wire, Plated and Un-plated
AMS 5542, AMS 5598, AMS 5667, AMS 5671, AMS 5698, AMS 5699, MIL-N-7786
Alloy X750, with the addition of titanium and aluminum, is a nickel-chromium precipitation-hardenable alloy having high creep-rupture strength at high temperatures to about 130.0°F (700°C). It also has excellent properties down to cryogenic temperatures. Excellent corrosion and oxidation resistance and high strength at temperatures up to 1300°F
Seal and other rings for gas turbines
Nickel + Cobalt: 70.00 min
Columbium + Tantalum: 0.70-1.20
Manganese: 1.00 max.
Silicon: 0.50 max.
Sulfur: 0.01 max.
Copper: 0.50 max.
Carbon: 0.08 max.
Cobalt: 1.00 max
Density: 0.299 lbs/in³, 8.28 g/cm³
Mean Coefficient of Thermal Expansion: in/in/°F (mm/m/°C):
70-212°F (20-100°C) 7.0 x 10-6 (12.0)
Modulus of Elasticity: KSI (MPa)
31.0 x 10³(213.7 x 10³) in tension
11.0 X 10³ (75.8 x 10³) in torsion
Melting Range: 2540-2600°F (1393-1427°C)
Mechanical Properties at Room Temperature
Properties: Annealed Typical
Ultimate Tensile Strength
135 KSI max (930 MPa): gauges < 0.040 inches
145 KSI max (10000 MPa): gauges 0.040- 0.060 inches
150KSI max (1034 MPa): gauges > 0.060 inches
Elongation: 20% min
Alloy X750 can be cold rolled to achieve the temper properties required by specific customers and/or manufacturing requirements. Contact Ulbrich Wire for details.
Alloy X750 can be heat treated. Contact Ulbrich Wire for additional information
Refer to NACE (National Association of Corrosion Engineers)for recommendations.
Standard Wire Finishes
Extra Clean: Extra clean is also referred to as “bright annealed” or “bright annealed and cold rolled”
Grease (round wire only): Drawn in a heavy grease produces an “Ultra bright” finish for decorative applications
Soap (round wire only): Soap is used as a lubricant in the drawing process and is not removed. It acts as a lubricant during customer part forming operation. A soap finish is available in tempered products.
Plated: Many plating options are available.
∗Special finishes are available: Contact Ulbrich Wire Sales with special finish and plating requests.
Cut to lengths
Alloy X750 can be hardened by:
Cold Working followed by Age Hardening
For best results refer to: SSINA’s “Welding of Stainless Steels and Other Joining Methods”
Inconel® X750 is a registered trademark of Special Metals Corp
Limitation of Liability and Disclaimer of Warranty: In no event will Ulbrich Stainless Steels and Special Metals, Inc., be liable for any damages arising from the use of the information included in this document or that it is suitable for the ‘applications’ noted. We believe the information and data provided to be accurate to the best of our knowledge but, all data is considered typical values only. It is intended for reference and general information and not recommended for specification, design or engineering purposes. Ulbrich assumes no implied or express warranty in regard to the creation or accuracy of the data provided in this document.
Copyright© January 2014 Ulbrich Stainless Steels & Special Metals, Inc. – Revision 6.1.2015